Just updated.... and

Cal Dawson · Mar 15, 2016

now I cannot set the RTH altitude, shows the different settings but as soon as I move it it changes back to what was set... Anyone else notice this?

App 2.1.0
Solo 2.1.0
Autopilot 1.2.23
Controller 2.1.0
Firmware 1.2.8

Just noticed every time I restart the altitude limit resets to 60M what goes?

pyrate · Mar 15, 2016

turn on advanced modes?

pyrate · Mar 15, 2016

Plus I think the current app is 2.2

Cal Dawson · Mar 15, 2016

pyrate said:
turn on advanced modes?

Just checked and no difference, also noticed performance always drops to the minimum level...

Just took a look and app is now at 2.2 but still no change....

pyrate · Mar 15, 2016

never heard of that, you might try uninstalling the app and reinstalling it.
also you did not say if this is android, but do the same with 3dr services.

I also assume you are connected to solo when you are trying all of this

Cal Dawson · Mar 15, 2016

pyrate said:
never heard of that, you might try uninstalling the app and reinstalling it.
also you did not say if this is android, but do the same with 3dr services.

I also assume you are connected to solo when you are trying all of this

yes I am connected to the solo when trying this, I am using Android without any issues...up to this point...

XperienceVisuals · Mar 15, 2016

Had the same problem. Just kept messing with it and was able to finally to make it change but it definitely wasnt responding correctly. This was with 2.1 as well. Havnt updated to 2.2 yet.

Cal Dawson · Mar 15, 2016

XperienceVisuals said:
Had the same problem. Just kept messing with it and was able to finally to make it change but it definitely wasnt responding correctly. This was with 2.1 as well. Havnt updated to 2.2 yet.

Just uninstalled and reinstalled, both the app and services. No change? maybe 2.2 will fix this...

Just checked again and app is 2.2 but still not working

RichWest · Mar 16, 2016

You could ID the issue is the app or Solo, by going into Tower and adjust a parameter and see if it sets. If it does it's the app, if it doesn't then it's either the controller and/or Solo. If you do try it make sure to correct your change from Tower after you've confirmed.

I got no suggestion as to which parameter....