So I was following the steps to install opensolo4 via SSH (Install via SSH) onto a factory reseted stock 3DR solo. I should have throughly read the instructions, as I missed the part that said "If you are upgrading a stock cube that still has the old 3DR 1.3.2 or 1.5.4 ArduCopter firmware, you need to install ArduCopter 4.0 first!" in doingso, I did the Controller IMX and Controller IMX steps first and when I realized I missed installing arducopter, I tried moving the arducopter.apj file into /firmware and rebooted the copter. rookie mistake, because I am stuck in some weird state and cannot get out (see video on imgur link). anyone know how to revert everything to before and start fresh?
I was able to pair the the copter with the controller even in this weird state, however, I dont know what to do next... any help much appreciated
I was able to pair the the copter with the controller even in this weird state, however, I dont know what to do next... any help much appreciated