I recently installed the Green Cube in my Solo. During my shake down flight I clipped a tree at about 6' up which sent the Solo into the grass. Thanks to the low altitude and speed there was no damage. The gimble opperates normally and I have all GP funtions and control on my Solex app.
I'm on v3.0 to maintain the auto on feature. Since my GC install I notice that in the Solo boot up the gimble engages and turns on both my H4B and H4S then at the end of the Solo boot up just when the Pod LEDs switch to flight mode the gimble goes limp and reengages. A quick down and back up. Additionally now neither of my GPs power off when the Solo powers down.
As this was my first GC flight I'm not sure if what I described above is the 'new' normal for the Green Cube or a result of my crash?
I'm on v3.0 to maintain the auto on feature. Since my GC install I notice that in the Solo boot up the gimble engages and turns on both my H4B and H4S then at the end of the Solo boot up just when the Pod LEDs switch to flight mode the gimble goes limp and reengages. A quick down and back up. Additionally now neither of my GPs power off when the Solo powers down.
As this was my first GC flight I'm not sure if what I described above is the 'new' normal for the Green Cube or a result of my crash?