Unable to boot/connect the Solo after, because the cube now says:
This is a stock cube, modified for 5v PWM output.
And it is stuck in a initializing loop..
Of course, in this state factory reset of OpenSolo3.0 also fail.
same with the firmware inside "ArduCopter 3.7-dev FW Only 2019-04-27"
both fail to run on stock cube..
Can you please point me to current firmware that will run on the stock cube (with 5V PWM output, so it is safe)
Code:
[MAV 001:1] ArduCopter V3.7.0-dev (fb1c2cef)
[MAV 001:1] ChibiOS: d443078c
[MAV 001:1] CubeBlack-sol 0041002D 33345119 3238343
[MAV 001:1] Frame: QUAD
[MAV 001:1] Initialising APM
[MAV 001:1] Check BRD_TYPE: Failed to init CubeBlack - sensor
[MAV 001:1] Initialising APM
[MAV 001:1] Check BRD_TYPE: Failed to init CubeBlack - sensor
[MAV 001:1] Check BRD_TYPE: Failed to init CubeBlack - sensor
[MAV 001:1] Initialising APM
[MAV 001:1] Check BRD_TYPE: Failed to init CubeBlack - sensor
[MAV 001:1] Check BRD_TYPE: Failed to init CubeBlack - sensor
[MAV 001:1] Initialising APM
This is a stock cube, modified for 5v PWM output.
And it is stuck in a initializing loop..
Of course, in this state factory reset of OpenSolo3.0 also fail.
same with the firmware inside "ArduCopter 3.7-dev FW Only 2019-04-27"
both fail to run on stock cube..
Can you please point me to current firmware that will run on the stock cube (with 5V PWM output, so it is safe)
Last edited: