Ok guys.... had an issue with the led control firmware.... maybe yall can shed some light.... I used winscp to copy over the file then used the terminal inside SCP to run the install command... everything on screen matched the instructions (been doing this kind of stuff for years...very familiar with SSH and command lines) all lights on solo then flashes red about 10 times then "party lights" then completed the install... upon completion, solos front light began to flash... I used the reset command and it worked... all light commands that I tried worked flawlessly. I went to fly solo and was jittery as hell so I landed... from then on Winscp would no longer connect and every reboot had white rear and red flashing front lights.... I checked rev # of firmware and it showed autopilot at 93.4.2 ? or something close to that... had to factory reset and start over. That got me back to square one.