Controller Mode 4

[JGrayoc90]

Hi. I was wondering if anyone knows the Terminal command to program mode 4 into the controller.
This is the download from the controller for mode 2. You would think you would switch the roll and yaw. But when i looked at mode 1 setting it has those two switched. All i want to do is turn mode 2 into mode 4. I was wondering if anyone can help.

** Its under firmware when logged into the controller. From your computer Wifi **


[throttle]
stick_id: 3
direction: 0

[roll]
stick_id: 2
direction: 1

[pitch]
stick_id: 1
direction: 1

[yaw]
stick_id: 0
direction: 1

 

[DodgyTechie]

Hi. I was wondering if anyone knows the Terminal command to program mode 4 into the controller.
This is the download from the controller for mode 2. You would think you would switch the roll and yaw. But when i looked at mode 1 setting it has those two switched. All i want to do is turn mode 2 into mode 4. I was wondering if anyone can help.

** Its under firmware when logged into the controller. From your computer Wifi **


[throttle]
stick_id: 3
direction: 0

[roll]
stick_id: 2
direction: 1

[pitch]
stick_id: 1
direction: 1

[yaw]
stick_id: 0
direction: 1

I normally fly MODE 3 and i was pissed that it was not able to be changed from within the SOLO APP. I have raised a support ticket for it and was assured the Devs will look into adding it into a future release..Well i just bought the SOLO and needed to fly NOW..
1. Setup the SOLO to Mode 1 ( just to be on a base level - standard)
2. Download and install MISSION MANAGER
3. Setup laptop to connect to the SOLO wifi
4. Go to setup and into Advanced Parameters
5. look for the 'rcmap' parameter.
6. Here is where you can swap the sticks.
7. so for my MODE 3 i swapped the 'RCMAP_ROLL' with the 'RCMAP_YAW'

7a. MODE 1 default settings was
RCMAP_PITCH 2
RCMAP_ROLL 1
RCMAP_THROTTLE 3
RCMAP_YAW 4

8. MY MODE 3 settings
RCMAP_PITCH 2
RCMAP_ROLL 4
RCMAP_THROTTLE 3
RCMAP_YAW 1

9. save the settings to the SOLO
10. reboot SOLO
11. do a check with the props OFF to see if the remapping is as desired.

This may void your warranty tho..