Recent content by Pilot_Pete

  1. P

    Firmware 1.3.0 is out

    i have same/similar problem. I updated to 1.3 for Solo and Controller. After that the app said my GoPro (H4B) needed updating. I updated it to 3.0 and now I cant get access to the camera controls. The app reports "Invalid Camera Model Detected". I am running app on Android (Samsung Galaxy Note...
  2. P

    I give up trying to install 1.3

    All good now. Udated just fine and the email link didn't bounce. I'm guessing it was a problem at the 3DR end. Thanks to all. Bad weather here today so I will try it out tomorrow.
  3. P

    I give up trying to install 1.3

    Its very frustrating as the download takes ages and then to be dissapointed. No luck after re-installing the app, still has the same loop. I'll leave it till later today it is 2:18 AM here in Summer Time (GMT +11) PAL Country
  4. P

    I give up trying to install 1.3

    I have uninstalled the app. and Re-installed from the Playstore . System info: App 1.3.0 Solo 1.2.0 Autopilot 1.2.0 Gimbal 1.1.4 Controller 1.2.0 Controller Firmware 1.2.0 It appears to download the update to the app however after disconnecting from normal WiFi and connecting to Solo...
  5. P

    I give up trying to install 1.3

    My email confirm link doesn't work either. I am now re-installing the app to see if that works.
  6. P

    I give up trying to install 1.3

    Connected to Solo via Solo Android App. Get message " Updates Available" Click button "Download Update" Told to connect to home WiFi which I did and seemed to download updates i.e. progress bar running. After a while download stops and "Begin" button is available. I press begin and get message...
See more