Recent content by hobo solo

Hmm I'm experiencing a similar issue. Used to boot up and lock quickly now it takes it time with a lower number of satellite. Anyone else experiencing this? The GPS has been in about a year.

Thought so. Cheers.

In a similar vein. I had a quick peek at my battery capacity in parameters on Tower and it showed that Batt_Capacity was at 5200 though Batt2_Capacity was 3300. Now I'm assuming that Batt_2 refers to a copter on ardupilot running a second battery but would just like confirmation and if so why...

My batteries charge just fine. Its just the initial voltage drop off of is sudden causing RTL.

OK. I'm having this issue with all my original batteries. They initiate low battery warning and solo starts RTL within 1-2 mins of launch. If I cancel RTL and fly watching the voltage I get my usual 12-15 mins landing with aprrox 13.8V to 14V left on the pack. I suspect bad cells in all 4 cases...

thanks for the reply folks. I've done the happy thing (fingers crossed). Just got to head out and do my calibration. Here's the log if anyone fancies a peek. cheers

I'll give it a go. Whats the worst that can happen?

Issue this evening flying. Mag interference before take off. Gyro calibration failed then seemed ok. Took off in Manual. Solo starts drifting away to the right and down. Failsafe must kick in at some point and solo saved from an early death. I'll post logs when I figure out how. Forum...

GoPro Updates - Google Drive

Any chance of international postage? Maybe we can get a group buy going in the UK?

I did a factory reset all calibrations work fine now. Follow me on android, however, doesn't work.

Can I calibrate the compass from Tower?

Anyone have this issue? The app won't initiate calibration. Its doesn't play the little solo spinning graphic and seems stuck on the page before the calibration bar starts. Help!

I'd wait. It was far more stable on 2.3. Lots of unexplained glitches running Android 2.3 and Solo 2.4.

I'm bumping this back to the top because I still believe this is an issue. I couldn't exactly explain it before but Andrew has done a much better job than I did. The gimbal defo has issues holding level but will slowly readjust over the course of a shot. To me, thats not how it should work...