Recent content by Greck

Just ordered: Props balancing tool HDMI flat cable Relish 3D Moongel pads Mayan Robotics GPS board (my rev B is for sale now) Will write an update after...

Could you please point me what shield you are talking about? Thank you.

Thank you, I "reset" it in both ways and it works now :)

Oops, Thank you.

How I can download Tower for windows?

Hmm, I bought it from ebay, it says Pixhawk new removed from Solo, how I can check what reset do I need to perform? Or Factory reset will solve all issues in any case?

Good)) Thank you.

No, I found your instructions and will perform them today. Thank you: Now you're going to need to do a parameter reset on the Pixhawk to fix all the settings you bungled up. With any luck, this process will also fix whatever was causing the pre-arm failure that began this debacle. Connect...

I recently replaced the Pixhawk because of accelerometer failed and now I can pass the calibrations(was failed before), but I can't start flying because of "press-fly-to-start-motor" message. When it gets to hold fly to start motors the green bar goes across the screen and control vibrates but...

Hi Mike, Did you solve the question?

3DR Support reviewed the logs and said that it is something that isn't covered by warranty. So guys if you battery failed during flying - be prepared to buy new drone...

Hi All, Here is my story: I was flying as usual and suddenly the battery level drops from 53% to 5% and drone start coming home, but during the landing battery died to 0% and solo crashed from ~ 2m height. After I replaced battery solo was flying without any noticeable issues, but when I...

Nothing special. GoPro 4 Black without any filters. I don't know how to do it, could you please point me to the page with information about it? Thank you.

What do you think guys, what can affect video in that way that it is looks like that: I replaced the propellers, but it doesn't help. I reviewed the gimbal for defects and it seems like it is good, no issues found. What else can cause it? PS: Tested in different locations with\without...