Recent content by Bushie2016

  1. B

    M8N GPS installation problem

    The bepping u hear is gps not connecting its a gps warning beep Thanks, Daniel, much appreciated
  2. B

    M8N GPS installation problem

    Ive read about this happening before check the connector and make one one the pins hasent moved out of connector.
  3. B

    M8N GPS installation problem

    I've just updated from the standard version A to an M8N GPS. I made sure that the connection between the two boards was correct but when my Solo lit up a beeping sound occurred and would not allow me to connect to the controller. Any ideas on what the problem is?
  4. B

    New battery dies all at once

    I had a similar problem a couple of months ago when the drone was around 1km and returning home, when suddenly the battery dropped to 25% & then 10%%. Since I was flying along the water's edge, I directed it to shore and the drone crashed into hillside. I tried recharging the battery a number...
  5. B

    Polar Pro LED lights not working

    Yes, I did purchase them from Harvey Norman and I returned it to the store this morning along with the lights and explanation. Unfortunately the sales person stated that because it was a Public Holiday in Victoria, they couldn't do anything about it, but suggested I get in contact with3DR and...
  6. B

    Polar Pro LED lights not working

    I've checked with them and they said that it would be replaced, however I believe the problem is internal and since Solo it is still under warranty, I will return it. Thanks for your help. Cheers
  7. B

    Polar Pro LED lights not working

    I'm in Geelong, Victoria. I've checked with the info you sent me and it appears that the problem is the drone, and considering it is under warranty, I will be taking it back to the store tomorrow. Thanks again for your help. Cheers
  8. B

    Polar Pro LED lights not working

    Thanks for the info, I will give it a try tomorrow as it is nearly midnight here and I think it's time for bed.
  9. B

    Polar Pro LED lights not working

    After plugging Solo, I pulled back the rubber surface to get at the 2 wires that went to the lights. What voltage should I get across these 2 wires? I could also see a small red light blinking from inside the case.
  10. B

    Polar Pro LED lights not working

    Ok, I'll borrow one and se if I can get a reading. Tks
  11. B

    Polar Pro LED lights not working

    I purchased a set of Polar Pro LED lights for my Solo but they don't work. I was wondering if there is a way to check to see if power is getting through to the accessory bay?
  12. B

    New Owner

    Hi from Victoria, Australia Just purchased my solo a few days ago and presently setting it up. Looking forward to communicating with people with similar interests.