Stock parameters

[ZdroneZ]

How does one reset all of Solo's parameters to stock setup? I may have deleted my saved file when I switched tablets. Thanks in advance.

 

[nuggetz]

The defaults are stored on the solo. Have you changed any? You can check them with tower. I haven't used the solo app in a while so not sure if anything is available there


Sent from my iPhone using Tapatalk

 

[ZdroneZ]

Not sure. I started working with Tower ~month ago.


Sent from my iPhone using Tapatalk[/QUOTE]

 

[Jubalr]

How does one reset all of Solo's parameters to stock setup? I may have deleted my saved file when I switched tablets. Thanks in advance.

If you want to be sure, you can reset them to stock:

Please follow the next instructions in order to perform a full parameter reset to your Solo:

From Tower App
1.- Follow the steps shown.
2.- Open the menu and go to Parameters.
3.- Once you area at the parameters section search for the SYSID_SW_MREV parameter.
4.- When you find it please select the number written to the right of the parameter name, delete it and write a "0" (Without quotation marks).
5.- Once you have changed the parameter go to the upper-right part of the screen and select the three dot icon.
6.- On that drop down list please select Upload Parameters.
7.- Finally turn off your Solo and then turn it back on.
*Please make sure to do both level and compass calibrations after doing the reset.

 

[ZdroneZ]

Thanks. I'll give it a try this week. Good day.