No camera control.

[firerob49]

Okay this is what I'm dealing with any help would be greatly appreciated! First of all I had a crash back when I put it in Acro mode. Hit a tree my bad. Had the gimbal on with full control video feed Etc. After the crash the gimbal still worked with full control with exception of the video feed. I took the gimbal off checked all the wires everything seemed fine. Put on the regular mount. Have a video feed with exception of camera control cannot start video recording or take pictures using solex. Any thoughts?

 

[timgilley]

You have to use the gimbal to have camera control since the commands to the camera are fed through the edge connector on the gimbal. Without the gimbal start recording before arming the Solo.

 

[just_bruce]

You've damaged a solder point or two either on the hero bus connector or on the connectors for the data/power ribbon cable. The fact that it stabilizes points to hero bus connector