Ok so i am doing the dumb legs mod because in the very near future i plan to add retracts. Since im gonna be that far inside i was looking at other stuff i could do and the accessory bay expansion was something i found.
So my question is: should i fill in the rest of the pins from mainboard to accessory board since 3dr only felt the need to wire up from pin 1 to pin 13, leaving the other 10 pins wide open or should i only solder the ones i may need in the future?
I guess in short im asking if linking pins 14-23 will hurt anything? Id like to have em active even if i never use em, simply so i wont have to dig in that deep again if for some odd reason i do need to get to it...
So my question is: should i fill in the rest of the pins from mainboard to accessory board since 3dr only felt the need to wire up from pin 1 to pin 13, leaving the other 10 pins wide open or should i only solder the ones i may need in the future?
I guess in short im asking if linking pins 14-23 will hurt anything? Id like to have em active even if i never use em, simply so i wont have to dig in that deep again if for some odd reason i do need to get to it...
