Aftermarket gimbal issue

[dougputt]

Hi all

Trying to get my aftermarket gimbal working on the 3dr..It stabilizes but for the life of me I cannot get the pitch to work.

Have the wire from pin 14 on the motherboard going to the rx pitch pin, as well have the RC6 set to 1..

anyone?

 

[dougputt]

Finally got the cheap gimbal working...
No where in any videos or info I saw did anyone mention you had to change the parameter for gimbal in Mission planner from 3dr to servo...
Changed it to servo and channel 6 and did some tweaking and it works great for the gopro 3....will throw a gopro 7 on at some time i suppose.

D

 

[timgilley]

Send pics, info and the particular model you used. Thanks.

 

[dougputt]

Not sure the particular model.. It was off ebay.. 2 axis. Dji phantom replacement.

 

[AeriStudios]

Probably a dumb question here but did this require soldering?

 

[dougputt]

Yes

 

[dougputt]

pin 14 I believe...Just have a look through some of the discussions....
pretty tight area to get into, so if you don't have steady hands....

 

[makatanav]

pin 14 I believe...Just have a look through some of the discussions....
pretty tight area to get into, so if you don't have steady hands....

better to take apart and solder, if not - it's wery tight