Recent content by WaldoPepper

That's true, it is still a M8P L1-only chip. But it is an upgrade in terms of price (~halved) and I consider it an option for my other Solos, one of which still has the original GPS.

Hi, I searched for it, but the results were inconclusive... ;-) Does anyone know, if the new(?) Here 3 with UBlox M8P can be used with OpenSolo? I upgraded one of my airframes to the Here+ RTK several months ago and , IIRC, there was a small issue regarding the compass sensor which was solved...

...I think you can if you open it and look e.g. for the chip labeled "MAG1", schould read something like "A983****" for the HMC5983

On what device are you running Solex?

This looks very nice, but I think it's not exactly what I have in mind, since I already have a base station. Apart from that I will check it out, thanks for pointing me to it. It seems that the whole "GPS Injection" thing means repackaging RTCM messages into MAVLink packages and sending them to...

My rig is build around two u-blox M8T from here: UBLOX NEO-M8T TIME & RAW receiver board with SMA (RTK ready) - CSG Shop A good antenna can be found at digiKey: 33-3710-01-01 Tallysman Wireless Inc. | RF/IF und RFID | DigiKey I use the RTKLIB as a software: RTKLIB: An Open Source Program...

Hi, I have a DIY (u-blox M8T based) RTK rig I use mainly for setting up GCP's. Now I think about upgrading my (Open)Solo to the Here+ Rover GPS Module. One question at this point: do I need to run MissionPlanner to inject the base station NTRIP cast or are there setups possible to do...

Got one of these to engineer my GPS mast kinematics. Funny thing, I am unable to remove the fake battery... :-( Anybody out there who knows how to do that? It seems to stick in there in a different way than the original one...

..thanks for pointing me, very good! Seems the carrier board is the critical part ;-)

Hi, what is the original Pixhawk capable of doing after he gave way to a GreenCube? Can I use it in e.g. in a fixed wing and if yes, what accessories are needed? Which ArduPilot could be used in such a case? Thanks for your input Kai

I am definitely planning to go for the HERE GPS and already contacted Curtis for cables. But since there is obviously a new iteration of the HERE on the market (HX-06022 with the Honywell HMC5983 compas changed for a Invensense ICM20948) I am waiting until the community says this is fine with...

Thanks for pointing that out. Since a PxH GreenCube upgrade is on my list it's good to know what to look out for. As a side note: just found out that there are in fact non-gimbal Solo's with Rev. B GPS and shield mod, because obviously I got one. First thing I noticed when unboxing it was, no...

...by the way, I find this very encouraging ;-) Solo Servo Sweep - Hackster.io

Hi, ever since I was using DJI products in the past (several Phantom iterations and an Inspire 1) I desperately wanted something like the Solo accessory bay/port on DJI products. But they never provided it :-( IIRC you have to buy at least a DJI Matrice 210 to get something comparable.... Now...

Just out of curiosity (and because I am currently migrating form the DJI walled-garden to the OpenSolo ;-) how does the Pixhawk GreenCube address the ESC issue? I assume it's a software/firmware approach.....?