Recent content by Tracker

It sound like you don't have everything up-to-date, see attached for a parameter list from mine, I have used these parameters on 2 different Solo's and they both fly very close to the original 3dr Solo.

I started by setting my EKF to EKF2 instead of EKF3, arducopter 4 is still in testing of EKF3. Second would be set the PID’s, the P and I gains are quite a bit different from the factory 3DR Solo. Check the RC throttle end points and trim (I believe this is channel 3) the RC throttle is not...

The gimbal must be connected during software flash, the software on the gimbal is not actually flashed but the gimbal must be connected for the OS to enable the feature. I had this same exact issue with one of my solo's I upgraded and was testing a crash recovery without the gimbal, once I...

Additionally If the above procedures reverts both the Solo and Controller back to 3.0 then your Open Solo update did not complete. Perform the update again but once the Update install script for the controller and Solo complete leave both powered on and DO NOT touch any buttons, after about 5...

No sure if you found your answer to this or not. First; Power on Solo copter with the controller off, power on controller holding down both power and fly buttons until you see "Updating Please Wait this will take about 5 minutes" on the controller. Leave both controller and Solo as is DO NOT...