Recent content by Shaff 67

Will do, thanks

Will tilt up and down ok with slight input, but moderate down input it immediately goes almost full down and codes as stated in earlier post^^

I was trying it out on a table, I'll try it in flight this afternoon, but the gimbal would tilt almost full down and the message would appear on screen "manual camera controls error" (have to power solo down to reset) also, using a gp3 with the 3s weights.... they may be the problem

Installed nib gimbal. Will not pan, up and down works unless it's full down, that's when it codes out (manual camera controls error), I've seen something about stick and button calibration.. Sutty maybe, couldn't access .I'm new, so, any help will be very much appreciated.

You all are, I'll be leaning on y'all again... We're new to this, way more software interaction vs rc planes..

Thanks Dave, I was afraid DHR was going to be called on me because of the a$$ whippings it had already gotten!! It appears to be be fine now after going thru all of the cals.. I appreciate the offer!!

Thanks jimloss, I did as you said, she's working like a beaut!! Thanks again..

Thanks, I'll try that this afternoon

Just Bruce recommended a parameter reset (mrev) where is this?

Same, would a factory reset be recommended?

Thanks, I'll try it again.. Do you need a door weight??? lol

Sorry, I replied to my comment, did you see it?

Or mrev for that matters

I'm in parameters, I cant find reset in the parameters

Also< I have Tower if anyone can help me nav through it to maybe narrow down which compass might be defective.. Thanks for ANY help Shafford