Recent content by nezumi

Hi folks, I'm having an issue with the DIY battery reading from the solo tool. I have successfully hooked up the BMS to a brand new tattu lipo, I have fully charged the battery connecting it to the BMS powered it on and while powered on I disconnected the balance lead and power cord from the BMS...

I have been having weird issues lately. The here GPS goes into blinking yellow with a beep then back to green followed by a beep yellow led. I thought it could be a faulty battery though the battery seems fine with the solo tool I also tried my other battery started to do the same. I flew...

It was my stupidity that's one thing I forgot to do. a+b+ pause.

Thanks for the kind reply. It happened to quickly and my backyard being small I had no time to think so I quickly ran to try stop it so the motor pods don't get damaged by hitting the back of the brick walls. I have set my A button to Stabilise and B to manual. I think its best not to fly in...

Hi guys, recently I've flown a solo with Rev A GPS so I took it to my nearest park to test fly my 2nd Solo. I done a compass calibration and level on the spot the solo didn't perform as well as the mRo GPS u-Blox but it was flyable, the solo returned home as expected but not as smooth as mt...

Can I use the greencube with the mrobotics GPS Unit or does it have to be with "here"? thanks

I wont be using camera or a gimble. I've got a servo attached to it for payload to drop it into the ocean for fishing. One of the guys on youtube got 17 minutes + without a gimble or camera thats good enough for me.

Why not just do it yourself like it has been for a while with a Tattu 4s 5200 pack. I ordered two tatts and two multistar 4s much cheaper.

That should work . Mine bricked by using the Solex update to version 3 I have no idea why if I try updating again I'm worried it will get bricked again then have to go through tearing the whole unit down to access the SD Card.

I took out the SD card from the solo and the controller then I formatted it then put the stock firmware solo_0.6.10.sdcard factory reset then it bind successfully. I don't think ill be updating to version 3.

I just made the pin longer and opened up the hole a bit larger that way it does not put pressure on the servo which works perfectly.

Issue resolved

Hi, I've tried changing RC7_MAX and RC7_MIN with values down to 10 and it didn't change the servo trim. I have my servo set to RC7_FUNCTION Servo out function I've changed the RC7_TRIm from 1500 to 10 no go.

Hi guys I'm new to this forum I've recently got myself a 3DR Solo not long ago what can I say its a beauty and flies like butter really happy with the outcome now I'll get to the point why I got this drone in the first place I've decided to use this drone as a payload dropper. The servo works my...