Recent content by lamberto

hi hansolo, it´s a very interesting build¡ one question, were do you solder the wires from the servo, i assume that the signal one is soldered in the pin 19, but were do you solder the +5v and 0v?, in which pins? thanks for the answers¡ lam

hello Dogman1973, i have the nex3n, i can make a cable to trigger the camera, the process is explained in this page: Build a Raspberry Pi-Based Cable Shutter Release for Sony Cameras, the only thing i have to do is convert the pwm signal in a logical 5v or 0v signal (maybe with a attiny85). the...

hello vcd i am trying to use the 3dr solo controller to control a 2 servo diy gimbal for a sony nex, for the roll and pitch i will use the pwm channels 6 and 8 from the solo expansion bay, and for trigger the camera, i will use the channel 7, the problem i have is for trigger the channel 7 via...