Recent content by Jesters Drones

Profincn: For reference, the section that burned was the main system power supply. The GPS is supplied from the PSM, which is the little module that sits above the cube between the 4 cube mounting screws. So, nothing to do with the HERE. I replaced his GPS, anyway, and fly his original on...

Thanks Joe, my phone is on my website although after Today, I'll be leaving. But I'll touch base when I get back. You can email me direct at [email protected] Happy Thanksgiving to all!

Thommann, I don't doubt that it happened just after install, but my feeling is, as another user mentioned, something came into contact with the area that burned. Keep in mind the GPS is a 5v circuit, the only 2 wires i care about thar would cause something to burn, is power and ground. The...

Yes, I'd still like to see the other end, but I'm leaning that the GPS has nothing to do with this, regardless, I'll work with you to get you sorted.

Yes, That's correct. I'm looking into what that section on the board is as well.

Hi Thommann. That cable is correct, if possible, take the bottom cover off the gps puck itself, you need to pop it off the mast, there is one screw which opens a little panel door. I'd like to see that connector.

Hi Thomann. That's not good. I believe you got the kit from Jester's Drones, as such, if its caused by the HERE or the kit wiring, we'll make it right. Can you take a photo of the connector in the GPS side?