Recent content by JasonS

I'm selling my solo with green cube and wifi boosters with upgraded GPS and wifi cards (solo and controller) $500. Who wants It? I'm buying a dji mavic pro at Costco on Wednesday.

Hmmm. I really didn't take notice. It was very sunny and bright on the water...

How can I get a copy of my logs to this forum so someone here can decypher them?

Firmware is the 3.5 that you sent me a link to. Installed via solex. Powered up solo on the boat - powered up controller just after solo.

So i have the green cube - all works well on land.... but a total fail on the boat. The drone and controller synched up. But when I try to fly - even in manual mode - I get a 2 beep tone "deee dummmm". Any help or ideas here? The second I got to solid land - solo took off like normal...

I've never used mission planner. I'm totally lost with that app. Is it easy to figure out?

Ok - so I had my 1st flight.. the deee dumm beep disappears in different flight modes - such as fly manual... not sure why this is - bit my 1st flight was a success. I purchased the green cube to fly from a boat. I hope it works...

And I'm back:). I reset parameters - rebooted - installed firmware and parameters - rebooted. The gimbal and fly button work.... BUT...when the fly button is pressed and the gas gauge goes all the way (to the point where the props would spin) I get a weird 2 beep tone.. deeee dummm... any...

Ok. I will give this a try tonight... Thank you so much for your help on this!!!

Solex.

I'm pretty sure I did.... but since I'm having problems... maybe I screwed something up.... that's why I think I need to wipe and start fresh... is that possible?

Maybe I can wipe and reinstall... How would I do this?

I used the instructions and scripts frpm here GitHub - ArduPilot/SoloScripts

Hi Rich - thanks for the reply. This solo isn't a new one. I've had this one for about a year. All fw for solo was updated and flew just fine pre green cube update. So I'm stumped too...

No beeps when i press fly in normal mode - the button appears to do nothing. If is switch to manual and I press fly - the gas gauge progresses as it normally would and I get a beep beep tone - like error tone. Gimbal still won't work either