Recent content by Bradley d

You are 100% correct! Thank you and thanks to Kelly for the write up. I thought the slider woyld just appear. I didn't know you needed to go to the flight screen! Thanks again.

Tried that. It didn't work.

Guess im out of luck here. I now have turtle speed !!!

I recently updated 2 of my solos to open solo 4.0 from 3.0 using solex. Neither of my controllers have the slider to control speed and both seem to be flying at minimum speed. I deleted solex on my lg g6 and reinstalled and still have the same issue. Has anyone else had this happen? Any...

What mods if any do you have to your solo? Green cube? Open solo? Have you updated any software?

Any motors left?

Got any motors left?

Yes I did update solex and I did just install 3.6 beta. This is tbe 3rd flight since I updated.

Guys I was looking for a little help. One of my 3 solos- green cube new versIon MRO GPS came back from flight yesterday, changed battery and now reads 999 ft. Altitude. I reset paramaters did all calibrations and changed to a different controller and no fix. Any ideas?

I run the MRO Green Cube and new version shielding. I get 18-20 sattelites in 90 seconds with an HDOP OF.7. Remember that number of sattelites isn't as important as your lock on those sattelite. Any HDOP below 1 is considered excellent.

The cube is available at Jesters

Some guidance can be found here (Loading Firmware onto the flight controller — Copter documentation). You do this with the Solo powered off, and just the pixhawk plugged in by USB. Just follow the prompts. If it asks you if this is linux board, the answer is no. Since I don't know what state it...

Fly mamual

I would say not a chance of replacement. If they do post it here.