Recent content by AOtarolaR

hi XevetS! i need to restore the old stock pixhawk on a black cube, but the SSWT switch doesn´t work. is there any way to flash it or load it via USB?

hi! I don´t know, not sure about that, the gimbal was working perfeclty on 3dr firmware 2.4.2 and on OpenSolo3.0.0. It began to act weird when I upgraded to Solo3.7dev, no hard crashes, nothing, it was acting as it should until 3.7dev... reset params... new calibrations... all the steps on the...

tell tell me about it...! i had to open the drone and controller in order to to flash the sd to stock solo, reset the cube with sswt, upgrade again 2.4.2, and then upgrade to solo 3.0.0...

yeap... the camera is fixed on the gimbal... I never turn on Solo without a camera on the gimbal... it hiccups and dance WITH the camera on... :confused:

This is my secont attempt to install the 3.7dev. I am the kind of guy who reads and follow all the instructions step by step (Open Solo 3.0.0 working perfectly as the gimbal)... BUT (after reset params and calibration)... now i got these prearm: fence requires position (and there´s no geo fences...

hi there... how do you demagnetize the compass?

well... i know now this mod it is not necesary with the soon to come master 4 (3.7dev).. but i found this and i think it is interesting... i never was able to crack open the black cube (i couldn´t detach the clear plastic top hehe)

already done that... did´nt work either...

not luck for me :/

thanks... i will try that... i am tired of trying to keep this Solo up in the air but nothing seems to work... I reinstalled the original Rev A GPS (i was using an BN800 wich was working fine)... reinstalled AGAIN the original factory firmware (controller_0.6.10.sdcard and solo_0.6.10.sdcard)...

long story short... I was using Open Solo 3.0.0 and everything was great... then something happened and I had to reset with the SSWT switch and "downgrade" back to the original factory firmware (controller_0.6.10.sdcard and solo_0.6.10.sdcard) ... then upgrade the stock firmware with the 3DR...

well... i used a 16GB micro sd card and my Solo is back on business...!

yeap... i know that, and the "original" sd card on the copter is an 8GB card, and if you do the upgrade thru Solex there´s no capacity issues... but if you try to do it "manually" there is this problem (at least in my case, i tried on win10 and win7)... I had to use a 16GB micro SD card to do...

i´ll try "installing" the old 2.4.2 manually and then reinstall Open Solo via Solex... 3drobotics/open-source

yeap... i tried another 8GB card with the same result on win10 and win7 with balenaEtcher, Win32DiskImager and USB Image Tool (must be a windows thing) it has to be an 16GB card then... what I don´t understand is why when i did the install thru solex it fitted well on that 8GB card... anyway...