Recent content by XyPsBqcz

After pair complete, there is same message "Waiting fot Solo" and nothing again! Is Factory Reset turn off CH6 and back gimble till type to 3DR? I get the problem after I changed gimble till type to some other not 3DR, Servo, but another option, I don't remember it name ... If not, is there...

I tried to connect the drone and the controller. After many attempts by pressing the Pair button and restarting, a controller message appears. After holding down the A + B buttons, it displays Pairing. Then the message "Waiting for Solo" again does not want to reconnect. I found that through...

Not boot all lights green 3DR Solo Factory Reset Error Lights

From the manual... Start by powering off Solo. Usea paperclip or similar tool to press and hold Solo's pair button (Figure 8.3.2.1) while powering on Solo. Release thepair button after you see the internal LED adjescent to the Pair button start rapidly flashing orange. This signals thefactory...

Hello I have a problem with my 3DR Solo, it does not boot. I set up via Mission Planer, gimbal till control to CH6. But something was not working properly and I decided to try all types (3DR, Servo and etc.). When I chose (not 3DR, Servo, but another option, I don't remember it name ... I...

Is there way to bypassing or disable checking that message?

I did it. I took the VCC and GND from Gimbal data cable and only CH6 from PIN14. It works! But there is message on the transmitter "Gimbal not found" how I can remove that message?

Thanks! If I do that, will they work the right side gimbal controls on the transmitter?

Hi of all, I am new with Solo. Some days ago I bought a Solo. I have Tarot T2-2D 2 axis Gimbal: TAROT T2-2D 2 AXIS GIMBAL TL2D01 - FLYING MODEL AIRPLANE I need some help how to connect gimbal to use transmiter tilt controls. I read Solo gimbal data cable specification...