Recent content by Whitman99

Ya...I have a history with the word 'straightforward' : ) It doesn't matter which drive I select...I get the same error on each. I have since I started. It says Required 15693824 sectors Available 15523840 Sector size 512...then goes on to say 'the extra space does appear to contain data'...

I totally don't understand this sd card...as I showed you in the photo I posted I get 8 disks images showing up...2 sets of four...the 'Golden' folder only shows 98mb of free space...There is one drive that has 7.1G but I get the same error no matter what drive I try and write the OpenSolo image...

I do have one more question...after I reformat the Solo SD card and try and load OpenSolo with Win32DiskImager...or any disk imager for that matter I get an error that says...more space required then is available...sector size 512...the extra space DOES appear to contain data...and yes, the...

Ya...the internal lights on controller lead me to believe it's not the issue...hey man...thanks for that info...very informative...even for me ; ) Ive tracked down another Solo out in Ontario...Im out $400 but I don't really see another way forward. I'll keep working on mine but I think, as...

No way to use Mission Planner to diagnose a loose sd card? Im grasping at straws...I get that. ; ) This has to be a Solo issue and not the controller correct...no reason to re-seat the sd card in the controller?

No...Im in a smaller town...Kelowna, BC. Ive been asking at the hobby shops and I just get vacant stares. So there is nothing I can run in Mission Planner to diagnose a wifi problem on the Solo?

Ive also re-seated the sd card probably 10 times as well...it clicks and seems fine...that's all I can say about that.

Wow...this really is depressing...I have put everything back together...reset everything...I turn on the Solo, it runs through it's startup...blue lights...red lights, GoPro comes on and rotates. Startup controller after reset, try and pair...nothing...just 'looking for Solo'...Ive changed the...

Ya...GPS cable was unhooked...your link wasn't the tone but lucky for me I was just listening to Volbeat really loud...so when I clicked on your link I just about fell out of my chair. : )

Whenever I plug a usb cable straight into the Pixhawk it goes green and orange then just green...then the annoying loud chime goes off and just keeps repeating...not sure what the point of that is but whatever. Yes, I tried to pair the two with no luck...Im not entirely sure if it's a timing...

The Solo network from the controller shows up...I connect to it but all I ever see is 'the ssh manager could not connect to Solo'

I haven't put it all back together yet but as it stands now when it starts up that Pixhawk chime doesn't shut off but nothing has changed...can't connect to the Solo on any level.

The Pixhawk cube lights up green and orange then defaults to solid green

The two lights on the board inside the Solo are solid green and flashing orange

Ok...ran that parameter to 0...now Ive restarted it...it went through a factory reset cycle then that annoying chime came on for about a minute...it went off...Solo outside lights flashed and now the Pixhawk chime is on again and not going off...who thought that was a good idea??? What should I...