Recent content by Vito413

Thanks for the help. Will everyone give me their opinions, and ideas of other solutions and ideas for breakout boards and multiple accessories to add to my drone? Thanks again for all the help and input.

Thank you everyone for all the great help today. This is what a community can do. We should all strive to be friendly and helpful in all aspects of life. Yes I will keep you posted as to my out come and final decisions. I would also like to find ribbon connectors of that size as it would be...

Thank you for a response you are being very helpful. I want to add the lights from polar pro and a servo release drop mechanism, and maybe an anti collision strobe or some leg retracts. So I just want options really. The board has voltages and such silk screened on it and Pro-Tec has the list of...

Thank you for your help. This doesn't seem to be the cleanest solution to more ports. I was hoping for a clean replacement to the connector that is there. There are more pins on the breakout board than there are on the original connector. Do I need to solder the rest of the pins that I want to...

Now this is where my lack of knowledge comes into play. Do I leave the existing connector board in place, then plug in the piece I have and solder connections to the pins I want or need to use?

Ok but then whatnor how do I connect anything else to the port? I have a bunch of pins that need somewhete to connect. Do they go to the main board or do I connect them to any accessories I have?

I already have the board. But if you check it out ot is a male connector and the connector that is there is female. So do I plug it into the existing board or solder it to the main board. Then how does it connect to the chasdis shell? The screw mounts do not line up with the holes drilled in...

Has anyone used the Pro Mbni Break out board? If so can you help me with the installation? I thought that it was a replacement for the board that was there but that doesn't seem to be the case. Any help would be appreciated. Is there a better solution for more power and options for the accessory...

Do you still have any of these boards?

I'm not sure how to pm you. I don't know how to find your email Or is this a place that is private?

Thanks for the info. I am looking for the original SOLO cable. To use there HERE gps I will need to change to something other than the stock software and firmware?

Hello first i am looking for a compass cable. Does anyone that has upgraded to the Here GPS and compass have one they want to get rid of? Second; When I upgrade to the here Gps and compass do I need to use mission planner, or can i continue to use the stock SOLO software and firmware. And...

Rich DJMc Sorry it has been such a delay to this post. You have replaced all of the screws with hex socket head screws? What size did you use? Are they all the same size? Other members have said that they have used M2-0.4 x 8mm. It seems to me that some of the screws are different sizes. Also...

Wow you answered me before I could even edit and write s proper post. Thank you so much, and ignore the next post.

Rickwest, Do you happen to know the size of the 4 pin click-Mate connector female side for the compass might be. I have found them in sizes like 100mm 150mm etc. Digo key seems to have a minimum order quantity of 3000. Do you know a place thsy I can get just a few?