Recent content by macmiket

Thanks for the comment but the problem is with the battery bay. The nut anchors in the body are fine but the bottom of two of the recessed holes in the bay were tightened too much, too many times. Consequently, the plastic thinned from compression one too many times and the bottoms fell out of...

I'm looking for a replacement Solo Battery Bay. Seems I was a eager when I was tightening two of the screws in the bay and the bearing surfaces have broken off. So, the screws no longer hold the bay to the board. I was even using Loctite on the screws. The moral, firm but not too tight. Please...

Thank you.

I purchased a couple of Green Cubes for two of my Solos. I have searched this site and others to figure out just what to do with the two strips of double-sided adhesive backed rubber included with the cubes. The rubber is perhaps 4 inches long, half an inch wide, and three-eighths of an inch...

Where is the Point of Origin for shipping?

I recently purchased a shade from www.aerialdroneaccessories.com for use with an iPad Pro 9.7 inch. The original shade would not fit the Solo iPhone/iPad spring clamp. After exchanging several emails with Stacy, which included suggesting design improvements, Stacy fabricated a new part for the...

Roland, thank you for the wonderful testing and information you have provided. I have recently acquired a Solo and made the mistake of reading, and reading, and reading. To date, I have replaced the stock motors with T-Motor 2216's 800 kv with APC props, installed the SOLO GPS upgrade, and I...

I have followed your posts from page 1 and am terribly impressed with the rigor with which you have carried out your testing, reporting, and perhaps more importantly, your educational insights. I have only one question. When installing the PA029 and PA030's on the T-MOTORS, do you use anything...