Recent content by Israbonanza

Ok I found the problem, the mount type was set to servo and it should be brushless. After uotading to the latest arducopter version it helped to find the issue. Thanx for the help! Now it's time to put this sucker in the air

Pitch and roll is on hold mode, yaw is in pan mode. It works as always, is the solo sending pitch values to the gimbal when I switch fly modes, in the video I'm showing the mount status values (position_a) it should be fixed unless it's flying in autopilot or doing automatic stuff (smart shots?)

Open solo 4.0.0 as shown in the radio

Yes storm 32 with pwm control only It doesn't lock since it only has pitch control with pwm, I stopped using the serial interface years ago since, not that you mention, when it kicks RTL, the gimbal yaw goes to stabilize mode, and if the drone yaws, the gimbal yaw stays pointing in its last...

SOLVED: INSTALLING THE LATEST ARDUCOPTER VERSION AND SET MNT1_TYPE TO BRUSHLESS INSTEAD OF SERVO Hi, I'm bringing my solo back to life, new motors, li-ion batteries, the old storm32 gimbal and a Sony rx0ii cam. It flies well, gimbal pitch controlled with the paddle all is happiness UNTIL I...

Actually you can get full control with a Firefly 8s you can take pictures and record video using pwm output channel 6, 7 or 8 and solex and the remote control cable

I set it to Lipo charge 4S at 3A (the same rates as the stock charger) and it works

If it's a Storm32 v1.3x it supports mavlink serial communications. Get the Storm32 gui and mission planner. On the solo gimbal cable use the white, green and black. White goes to rx, green goes to tx and black is gnd. On mission planner set the parameters for uart 4 baud rate 115200,protocol...