Recent content by gpang.btr

take a look at madhacker.org and if you like the 3DR Solo as I then try a couple of the universal BMSONE .. I have two on order to try out and can't wait to put the battery BMS mod into the air... Happy flying

I have 6 3dr solo's and I fly 3 of them every other week to to check on my updates and mods that I install - Slowly upgrading and modifying them to Solex

On samsung 6s KNOX is no longer available but was the current release during the 3DR Solo era

I use Solo version 2.4.0 on my galaxy 6s

I also bought 7 3DR Solo's off Ebay and got 6 of them to function flawlessly - updated all 6 with Neo-M8N GPS - Now working on building standard Lipo battery packs with redesign battery shells to keep this drone in flight worthiness...

I just got off the mRo site and Peter Killgood suport agent said that request for the mRo gps 3dr solo are still being received - go ahead and place a pre-order for their gps module - I have purchased 4 of these myself and have not had to re-config the gps module for sat receivers - BUT I can...

Total agree with the detailed steps Woods described above... especially saving the org sd cards and using new ones - just to have a backup in case something goes wrong... Well documented in detailed Woods...

Since I am new to 3DR Solo (just bought the 4th one off EBay from those who are getting out within the last 3 weeks) but not to FPV builds I did come across some posts about issues with the IOS and Solo app. Just looking at the 3DR company dropping what I can now say since I now had one to test...

3drobotics/open-source I followed this post that I found and just updated the micro ssd cards directly in both the 3dr solo and controller

I came across this and just decided to add the firmware directly to the sd cards so that I would know for sure both drone and controller were on the same firmware version... https://github.com/3drobotics/open-source/blob/master/solo%20instructions.pdf

the 3dr solo drone is the wifi "source" that you set your phone/tablet and controller to...

I had that same problem when I did a factory reset BUT after watching the controller I got the message that the FIRMWARE versions were NOT the Same... I had to reinstall the same version of the firmware on BOTH the controller micro sd card and drone sd card before I could get pass the pairing issue