Recent content by Dmitry

Thank you Sir.Frenz! Happened!

Will it be loaded correctly?

which file exactly? this? but I failed

Nothing happens! Tried several times, solo does not want to see the new firmware!

Would be made a 5 volt mod and installed ArduCopter-3.5.2_Firmware.px4 firmware. but the ArduCopter-v3_3.5.4_Solo.px version is not installed, why?

Thank you!

fat32 or fat or exFAT?

short video and what sound

And how is it formatted? FAT32?

Something went wrong! I decided to restore the map of the Copter through the recording on the SD. OPEN SOLO 3 was installed. In the solo are 2 SD cards. One in the PIXHAWK 2 cube to get it, you need to parse the cube. And one is on the motherboard from the bottom. I accidentally overwrote the...

Or first make a reset or reinstall open solo? and after that try again to install ArduCopter-v3_3.5.4_Solo.px4?

It turned out, thanks for the help! I stopped at the next, I do not understand why it is not installed? Put the firmware (ArduCopter-v3_3.5.4_Solo.px4) in the catalog /firmware, rebooted the solo but the installation did not go, what did you do wrong? Waited a few minutes. May need to give a...

put the firmware (ArduCopter-v3_3.5.4_Solo.px4) in the catalog /firmware, rebooted the solo but the installation did not go, what did you do wrong?

Do I need to cut this segment? and solder the wire to 5 volts?

No one knows?