I had to send the drone back to B&H and get a new one. Once the new one arrived I made sure I activated and updated the drone and flew it off the ground before installing the Gimbal on it. Works very well, no issues at all. I don't know if the first drone I received was just defective, or maybe...
I had a slight weird feeling that might have been the issue... I even thought for a second, while unboxing everything "Should I just get the drone ready then install the new gimbal?" ... At this point i'm definitely going to try it though.
Thanks for the support Raybro.
That's good to keep in mind. I'm not usually one to be an ass but after waiting for 2-3 Months specifically for this drone it's very frustrating to not get a properly working one. I really don't want to resort to getting a Phantom 3, the functions of this are really what made me go with it so...
Ahh its good to hear someone else had the same issue. I think i'll spend part of today trying to do a factory reset, and replacing the gimbal with the stock one then reinstalling everything. I ordered the drone and gimbal from BnH so I hope if I need to exchange it they'll make things quick...
I received my 3DR Solo, and goPro Gimbal, I have all the latest firmware yet when i go to power everything on and my remote begins "Calibrating Sensors" it just stays in that stage for 30minutes +
I've tried doing both manual calibrations, and my results are:
Level Calibration - Consistently...